User Manual
English
Connections
Transmitter KVM Interfaces
▪
DisplayPort (Female)
▪
USB Type Mini-B (Female)
Transmitter Extension Port
▪
SFP Multi-Mode Duplex
Receiver Console Interface
▪
DisplayPort (Female)
▪
3 x USB Type A (Female)
Receiver Extension Port
▪
SFP Multi-Mode Duplex
Installation & Operation
1. Connect a DisplayPort cable from the display to the DP Output port of the receiver.
2. Connect USB HID devices including keyboards and mice to the USB Type A ports of the receiver.
3. Connect a DisplayPort cable from the source device to the DP Input port of the transmitter.
4. Connect the source device to the Mini-USB port of the transmitter.
5. Once the modules are fitted, carefully connect a duplex LC OM3 multi-mode fibre optic cable to the
ports on the TX and RX units, ensuring that the fibre connection is crossed over.
6. Connect the power supply to either side of the installation and power on.
7. Turn on the display and then power on the source device.
Please ensure when the video source is powered on, the display is connected to the installation for EDID
communication. If this is not correctly connected, there may be no video content displayed.
Please note: USB webcams, USB Mass storage and wireless USB devices are not supported
Transmitter Unit
1. Power / Connection LED: Please see below for the different LED Indication definitions.
2. Mini-USB PSU Jack: Connect the included power supply.
3. Optical Out: Connect the SFP Module and Duplex Fibre Cable.
4. DisplayPort
In:
Connect
the
DisplayPort source device via DP
cable.
5. USB In: Connect to the USB Host
PC.
6. USB Status LED: Once USB HID
has been connected, this LED will
emit Orange. This will flash 1-3
times to indicate the connected
device number.
Summary of Contents for 39376
Page 2: ......