SOD
A W
ATER MAKER
S
9
12. PUTTING INTO OPERATION
1. Connect the device to CO
2
supply.
2. Connect the device to water supply.
3. Check that all the joints and connections are sufficiently tight.
4. Connect the device to the power mains.
5. Turn on the device using the main switch.
6. Use the Soda or Water button to pour a drink.
WARNING:
If you discover a leak, turn off the device. Fix any leaks found on the tubing. If
a leak is found inside the device or you are unsure how to proceed, contact a service centre.
11. HOW TO WORK WITH SPEED FITTINGS:
11.1 Speed Fittings Installation
Grasp the rapid coupling and insert the hose
all the way inside the speed fitting body (ca. 20
mm). The end of the hose must be straight so
that it plugs fully into the coupling. If the hose
will not go in, moisten the end of the hose.
Hold the grey ring tight against the body of
the rapid coupling and pull out the hose.
11.2 Speed Fittings Removal
WARNING:
If you do not hold the grey ring but pull at the hose, the speed fitting will cut
even deeper into the hose.
WARNING:
Hoses must not be pressurised during removal.
figure
9 a
figure
9 B
