C-185 Manual
11
C-185 Manual
12
5. Fit the floats into place on the fuselage instead of the landing gear as shown.
6. Connect the float servos to the rudder channel as shown.
7.Fit the battery cover well as shown, you can change the battery easily
by open the cover, and you can install numeral product like camera,
lighting system ect into it.
Parts:
1.Fuselage
2.Main wings
4. Fit the aluminum float struts as shown.
1).Fit a small plastic bag or balloon over the receiver to waterproof it,
then seal the neck of the bag over the servo wires using a rubber band.
2).Salt water is not recommended, it will destroy the electronics quickly.
If you do end up getting salt water on any of your electronics,
immediately rinse the electronics in fresh water.As soon as possible.
3).If you end up soaking any of your electronic components in fresh
water, you can simply let them sit in the sun to dry off, usually, they will
start working again when they are dry.
Some tips for flying off water as follow:
4).If the water is too smooth, the suction of the surface may keep the
plane from taking off.In this case, circle around on the water to create
some waves, then run across the waves to take off.
5). Check that there is no water inside the fuselage before each and
every flight. Water inside the fuselage can wash backwards during
takeoff, change the center of gravity, and cause a crash.
6). After a water flying session, it is VERY important to dry the airplane
and motor thoroughly before putting it away.7). Only fly upwind of
yourself. If you run out of batteries, and the plane is downwind of you,
you have no way of getting it back to shore. If you fly upwind of
yourself, the wind will bring the plane back to shore.
Modellbau Lindinger GmbH e-Mail: [email protected] www.lindinger.at
Modellbau Lindinger GmbH e-Mail: [email protected] www.lindinger.at
