855
Dual Mono Power Amplifier
Setting up
Place the 855 in the location in which you intend to use it. Do not try to move
the amplifier when there are cables connected or when it is switched on.
Connect your other components using high quality interconnects and speaker
cables. Make sure that the polarity of the speaker cables is correct. Now, plug
your power amplifier into the mains. Before you do this, use a phase finder to
determine which conductor on your distribution board is live. The live
conductor should be connected to the pin marked red on the 855's IEC socket.
Switching on and off
Switch the 855 on with the power switch on the rear of the unit. The 855 is
now
in
standby
mode. The blue 'on' LEDs will illuminate briefly. To switch
the unit on and off, press the POWER button. When using the SYSCOM cable,
the power amplifier will power up at the same time as the preamplifier.
The blue LEDs remain illuminated during normal operation.
SYSCOM
If the 855 is linked to an 800-Series master unit, the latter takes over remote on
and off switching. Remote switch-on is only possible when the 855 is in
standby mode. It is also possible for a component in the chain from another
manufacturer to remotely switch the 855 on and off via a Remote link. The
switching voltage must be between 5V and 12VDC.
Lindemann audiotechnik can supply adapter cables upon request.
Slave
Master
855
Power
Amp
820/830
SACD/PreAmp
855
optional
9
