Linde BOC RAPTOR, Operating Manual

Page: 52 / 56

52
Faults symptom Reasons Solution
1 1 No display on panel
2 No welding current
output
1 Not connected to the power
supply
1 Make sure the input power
supply is normal.
2 Make sure the power switch is
closed.
2 1 The display of the panel
is normal.
2 No welding current
output
1 The input voltage is wrong.
2 The input voltage is unstable
1 Adjust the voltage to the
correct value.
2 Turn off the machine, and then
turn on in 5–10 minutes.
3 The wires between power
switch and power supply
board are loose.
3 Re tighten the wires between
power switch and power
supply board.
3 1 Fan is not working
2 It has abnormal
indication
1 The fan is broken.
2 Internal fault
1 Contact BOC or authorised
service agent.
2 Contact BOC or authorised
service agent.
4 1 Fan is working, it has
abnormal indication
2 No welding current
output
1 Overheat protection.
2 The circuit of auxilliary
power supply is broken.
1 The machine will automatically
return to normal in 5–10
minutes.
2 Contact BOC or authorised
service agent.
5 1 The text in the panel is
incorrectly displayed
2 Parameter values cannot
be adjusted correctly
1 The display cable has a poor
connection.
1 Contact BOC or authorised
service agent.
6 1 Power switch doesn’t
work
1 Power switch is broken.
2 Three phase rectifier bridge
is broken
1 Contact BOC or authorised
service agent.
2 Contact BOC or authorised
service agent.
7 1 Press the TIG torch
switch, it has no gas flow,
but has current output
1 The solenoid is faulty.
2 The gas supply.
1 Check the supply.
2 Contact BOC or authorised
service agent.
8 1 Press the TIG torch
switch, it has no gas and
current output
1 The torch switch is broken or
bad connection.
1 Check the torch switch and
torch connection.
2 Contact BOC or authorised
service agent.
IMPORTANT:
Only authorised repair agents with valid certifications should carry out repairs
and internal servicing.
13.3 Fault Finding