Overview
This service page details the procedure that
must be followed while operating the
portable oil drain and extractor system.
All required parts, tools, and equipment
needed to complete the assembly and
operation of the portable oil drain and
extractor system are defined and listed
within this manual.
Review of the manual, parts list and
nomenclature is recommended before
starting operation.
General description
and information
The portable oil drain/extractor system is
designed to safely capture oil from engine
crankcases with the use of a vacuum or by
use of the funnel drain system.
An external air supply is required to run
the extractor.
When the tank is full, the tank is emptied
using air pressure.
Table 1
lists the specifications of the
portable drain and extractor system.
Table 2
lists the sub assemblies of the
extractor system.
Do not exceed maximum specification
ratings.
Table 3
details the specifications for the
different suction wands that are part of the
extractor system.
Refer to
fig. IPB 1
,
page 7
for the
illustrated parts breakdown of this assembly.
Inspection
Inspect this equipment for damage prior to
use that would prevent the equipment from
operating as intended.
Damaged equipment
Do not use this equipment if it appears to be
damaged, badly worn or cannot be operated
as directed by this user manual.
Any other use not in accordance with
instructions will result in loss of claims for
warranty and liability
A listing of authorized warranty and
service centers is available upon request.
Fig. 1
Table 1
Specifications
Tank size
Holding
capacity
Suction rate
1)
Pressure
relief valve
Air pressure
for vacuum
Maximum pressure
for emptying
24 U.S. gal.
(91 liters)
16 U.S. gal.
(61 liters)
1.5 U.S. gal/min.
(0,4 liters/min.)
14 psi
(1 bar)
100 psi
(7 bar)
7 psi
(0,5 bar)
1)
Waste oil temperature at a minimum of 158 °F
(70 °C)
with a 0.24 in.
(6 mm)
diameter wand.
Table 2
Specifications
Level gauge
Gallons and liters
Tool tray
Six suction wands
Refer to
table 3
Suction hose
79 in.
(2 m)
Two adapters
Refer to
table 3
Discharge hose
79 in.
(2 m)
Vacuum gauge
Muffler
Caster
4 in.
(101 mm)
, rubber tread, ball bearing
Wheel
6 in.
(152 mm)
, rubber tread, ball bearing
Table 3
Suction
wands
Suction
adapters
Material Dimension
Material Use on automobile
Copper Ø 0.2 in.
(5 mm)
x
27.5 in.
(700 mm)
Metal
BMW
Plastic
Ø 0.2 in.
(5 mm)
x 27.5 in.
(700 mm)
Metal
VW
Plastic
Ø 0.24 in.
(6 mm)
x 27.5 in.
(700 mm)
Copper Ø 0.24 in.
(6 mm)
x 27.5 in.
(700 mm)
Plastic
Ø 0.28 in.
(7 mm)
x 39.4 in.
(1 000 mm)
Plastic
Ø 0.32 in.
(8 mm)
x 27.5 in.
(700 mm)
*Indicates change
4