12
DESIGN
CASE BACK
CASE REAR COMPONENTS DESCRIPTION
INTERNAL CONTROLS
INTERNAL CONTROLS DESCRIPTION
1.
Spool Gun Switch
–
Permits toggling between standard push gun
welding with the Magnum® Pro 1
00
L or aluminum welding with the
Magnum® Pro 100SG Spool Gun.
2.
Wire Drive Tension Pressure Adjustment
–
Permits increasing or
decreasing the pressure applied to the top drive roll.
3.
Wire Drive Spindle
–
Supports a 4-inch or 8-inch spool of wire.
The
center wing-nut can be adjusted to increase tension on the
wire.
4.
Replaceable Wire Guide
–
Select the correct inner wire guide for
the desired wire diameter. The outer wire guide provided can be
used for any wire diameter.
5.
Replaceable drive roll
–
Select the correct drive roll for the wire
diameter and composition being fed.
6.
Gun Connector Block
–
Permits securing a welding gun to the
wire
drive by ensuring the gun connector is fully seated, then
tightening
the large knob
FIGURE A.2
FIGURE A.3
1
2
6
4
5
3
1.
MIG Gas Solenoid Connector
- Connection for the gas hose of
the
MIG shielding gas.
2.
Thermal Breaker
- The Power MIG® 215 MP
i
TM
features a
resettable 25 amp thermal breaker. If the current conducted
through the breaker exceeds 25 amps for an extended period of
time, the breaker will open and require manual reset.
3.
230V Input Cord
–
Hardwired 230V input cord. 120V to 230V
input adapter included for easy 120V compatibility.
1
2
3
POWER MIG 211i
®