A-9
INSTALLATION
LF-74
A-9
WELDING GUNS, TORCHES AND ACCES-
SORIES
GUN RECEIVER BUSHING
The LF-74 wire feeder comes with a K1500-2 gun
receiver bushing.
MAGNUM GUN AND CABLE ASSEMBLIES
The LF-74 wire feeder model will accept a number of
optional gun and cable assemblies. An example of
installing the Gun and Cable is shown in
Figure A.3
with a 15 ft. (4.6m) long
Magnum 400
gun and cable.
Figure A.3a
with a 15 ft. (4.6m) long
Magnum Pro
350
gun and cable.
1. Turn off power at the welding power source.
2. Unscrew Thumb screw on Wire Drive Unit, until tip
of screw no longer protrudes into gun bushing hole
as seen from the front of machine.
3. Fully insert the gun cable connector end into the
gun receiver bushing and gently tighten the thumb
screw as show in Figure A.5.
4. Connect the gun trigger connector to the trigger
receptacle. Make sure that the key ways are
aligned and insert.
FIGURE A.3 for Codes
11195, 11196, 11197
FIGURE A.3a for Codes
11610, 11611
Figure A.3
Figure A.3a
ARC WELDING SUPPLIES - 07 847 7870