Lincoln Electric HELIX T55, Operator'S Manual

Page: 24 / 52

15 INSTALLATION 15
en the tension knob slightly to give the rollers a
better grip.
FIGURE 32 – INLET GUIDE
6. Once the wire comes out the wire guide tip stop
feeding and snip the end to the appropriate
starting length.
Adjustments for Radial Clearance
To achieve minimal radial profile you should adjust
the wire arms to ride as close to the track as possi-
ble. To adjust the wire arms loosen the wire arm
thumb screw enough so that the serrated teeth can
slide past each other (see Figure 31
– Thumb
Screw).
Put the wire arm to the desired position and tighten
the thumb screw (see Figure 34
– Wire Arms Ad-
justed). The serrated teeth ensure that the wire arm
will not slip out of position.
FIGURE 33 – THUMB SCREW
FIGURE 34 – WIRE ARMS ADJUSTED