IS193 ECN3444
4
SECTION 2 – INSTALLATION
2.1 PREPARATION
Green neon (Mains on)
Amber neon (L/H Griddle Plate)
Amber neon (R/H Griddle Plate)
L/H Griddle Plate
Control Knob
R/H Griddle Plate
Control Knob
Fat Drawer
Remove all packaging and protective coatings prior to installation.
2.2 SITING
The appliance must be installed in accordance with the appropriate regulations listed prior.
For correct operation the griddle plate must be checked and adjusted for level during installation.
Any partitions, walls or kitchen furniture less than 100mm from the appliance must be of non-combustible
material.
The appliance should be installed on a level surface in a suitable position that is well lit, and positioned to
minimise the possibility of accidental touching.
A clear space of at least 100mm must be left to the rear of the appliance to allow for servicing with a clear
space of 600mm to the front to allow for safe operation. A minimum space of 100mm must be left
between any side of the unit and any combustible surfaces or walls.
2.3 ELECTRICAL SUPPLY AND CONNECTION
Connection of the electrical supply cable is made at the rear of the unit. Lift the protective cover and fit a
suitable cable into the strain relief and then to the inlet terminal block. The unit is supplied for
connection to a three-phase supply.
