IS 615 ECN 3862
Page 7 of 10
Error codes
There are numerous error codes identifying issues within the induction system.
These are primarily of use when reporting a fault to
Lincat’s Service Department;
however some errors can be cleared by turning the control to the ‘Off’ position,
unplugging the appliance and then switching back on again.
An illuminated red LED indicates an error.
The generator error codes are displayed in a series of flashes of the green LED.
There is a long flash followed by a series of shorter flashes.
The number of these short flashes is the error number.
A reduction in performance during cooking may be attributed to a blocked or
restricted air filter, a confined location with insufficient airflow or a failed cooling fan.
Pan detection function
Each zone has pan detection which prevents the coil from turning on without a pan
being present. The coil also turns off when a pan is removed.
OVEN SETTING
Check the green ‘power on’ neon on the fascia panel is illuminated.
Set the control knob to the desired temperature in degrees Celsius. The
orange light will illuminate indicating that power is being supplied to the
elements.
The orange light will go out when the oven has achieved the set temperature.
Periodically the orange light will illuminate to indicate that the oven
temperature has fallen and the elements are turned on to top up the
temperature.
SHUT DOWN
To shut down the appliance rotate all control knobs clockwise to the OFF position.
After operation, some parts of the appliance will remain hot for a period of time;
care should be taken to avoid risk of burns.
OPENING OF THE OVEN DOOR
Care must be taken to avoid injury when opening the oven door when the oven is
in use, as hot air will rapidly escape.
