Linak DESKLINE DB5, User Manual, Page: 18 / 28

Page 18 of 28
Initialisation of the DESKLINE DB5/DB6 parallel systems
The DESKLINE system is intialised by pressing the down key once or twice and holding it down until DB5/DB6 runs into end
stop, it will then automatically run approx. 3 mm out again. Only release the down key when the movement has completely
stopped.
If the key is released before the sequence is complete then the initialisation is interuppted and must be started again
from the beginning.
It is sometimes necessary to press the down key twice to start the initialisation, this is because the system can be in different
modes when the initialisation starts.
Approx. 3 mm
The CBD5 and CBD6 can control the DB5 and the DB6 in 2 parallel while the CBD4 can control the DB5 and the DB6 in
2, 3 and 4 parallel so that the desk is always kept horizontals.