LMS7002M Quick Starter Manual for EVB7 kit
18 |
P a g e
Version: 2.2
Last modified: 29/09/2014
5
Getting started with the EVB
Introduction to using the EVB7
5.1
The EVB7 allows powerful demonstrations of the LMS7002M transceiver. In this quick start
guide, we demonstrate the board operating with analogue inputs and outputs. A future version is
planned to demonstrate the board operating with digital inputs and outputs and the Lime “Speed”
board.
Section 5.2 describes the set up of the transmitter, with Section 5.2.1 describing how to set up the
SXT (TX PLL) and Section 5.2.2 describing how to set up the TX analogue baseband and RF
tabs of the LMS7002M Control software. Section 5.4 describes the set up of the transceiver for
basic tests, with section 5.4.1 describing how to set up the SXR (RX PLL) and Section 5.4.2 and
5.4.3 describing how to set up the RX analogue baseband and RF tabs of the LMS7002M
Control software.
The analogue quick start demonstration assumes the user has all the equipment listed in
Appendix 8.2. Users with less equipment can use the set up of Section 5.6.
