LMS7002M Quick Starter Manual for EVB7 kit
16 |
P a g e
Version: 2.2
Last modified: 29/09/2014
Linux Setup
4.5
For Linux users, there is no need to install USB drivers as the system will assign drivers
automatically once the EVB7 board is connected to PC.
To determine port number the easiest is via the command line and type command:
$ setserial -g /dev/ttyS[0123]
Starting Control LMS7002M Software
4.6
Apply +5V to the board and start “Control LMS7002M” software. The application must be run
under administrator privileges. To do that, right click on the “Control LMS7002M” icon and
select
Run as an Administrator
. This will provide administrator privileges, which are required
for EVB7 board communication via USB.
Connecting
4.7
Once the Windows driver is installed and the control software has been lunched, click on
Options>Connection Settings.
The
Connection Setting
windows will pop-up (
).
Figure 8 GUI communication settings.
Select the dedicated USB port number of the EVB board. In this case, it is COM2, but the port
may be different, and press OK.
The GUI the device name and firmware version will appear in the bottom (
), once
connection with the board is established.
