-5-
E
n
g
lis
h
Emergency Factory Default
To restore the hardware to factory default settings, please follow
these steps:
1.
Press and hold “RESET Key” for 10 seconds and release.
2.
Wait for about 40 seconds, and the network LED light should turn
off, and go back on again.
3.
The camera is now restored to factory default settings, and will
reboot automatically.
4.
Search for the IP device using the IPScan software.
5.
Start the IP device via an Internet browser.
6.
Enter the default username “admin” and password “pass” to
operate.
NOTE:
For your convenience, the IP address will revert to the default
setting of 192.168.0.200.
Before Accessing IP Cameras
Before accessing the IP camera, make sure that the camera’s RJ-45
network, audio, and power cables are properly connected. To set the
IP address, consult your network administrator for an available IP
address. The default IP address for each IP camera is 192.168.0.200.
Users can use the default IP address for verifying the camera’s
network connection.
