Service Manual Golvo™ 9000
mobile lift
• 3EN400405 Rev. 2
6
www.liko.com
l
www.hill-rom.com
2.0 Troubleshooting, Golvo™ 9000 mobile lift
The lift cannot be operated
with the hand control.
1. Check that the emergency stop button has not been activated.
2.
Check the battery capacity.
Li-Ion battery:
Check
sleep mode / deep discharge (see below)
3. Check that the charger cable is not connected to an electric outlet.
4. Check that the hand control cable is correctly connected.
5. If the lift works via the operation panel, change the Hand Control.
6. If the problem persists, please contact Hill-Rom.
The lift does not work up/down
with the operation panel.
The base-width adjustment doesn’t
work (in/out) with the operation panel.
1. Check that the emergency stop button has not been activated
.
2. Check that the cables to the control box are connected correctly.
3. Check that the charger cable is not connected to an electric outlet.
4. Check the battery capacity.
Li-Ion battery:
Check
sleep mode / deep discharge (see below)
5. If the problem persists, please contact Hill-Rom.
The charger doesn’t work.
1. Check that the charger cables are connected correctly.
2.
Make sure that the battery is properly attached.
3. If the problem persists, please contact Hill-Rom.
The lift is stuck in the high position.
1. Check that the emergency stop button has not been
activated
.
2. Check the battery capacity.
Li-Ion battery:
Check
sleep mode / deep discharge (see below)
3. Check that the hand control cable is connected correctly.
4. If the problem persists, please contact Hill-Rom.
The lift does not reach maximum lifting
height.
1. Check that the lifting interval level is correctly set.
2.
If the problem persists, please contact Hill-Rom.
If any unusual noise is heard.
Contact Hill-Rom.
Li-Ion battery - sleep mode
A sleep mode will be activated in a Li-ion battery if the battery has
not
been in use or charged for more than one week. The sleep
mode switches of the battery and the electronics to save power.
The battery will stay in sleep mode until the battery is set back in
operation mode.
To set the battery back in operation mode;
Charge the battery until the “CHARGE”
yellow diode on the control box lights up,
it takes about 15 seconds.
If the yellow led do not light up, the battery
has entered deep discharge.
Follow information to the right.
Charging a
deep discharged Li-Ion battery
When charging a deep discharged Li-ion battery
the charger will start charging at a low charging rate
to protect the battery. During the low rate charging
no indicator will light up
.
When the low rate charging is completed
the charger will automatically switch to normal
charge rate and the "CHARGE" diode will light up
yellow and then turn off when charging is completed.
The battery is fully charged after about 4-6 hours.
Delay!
A delay to indicators for current battery power
at the control box and hand control occurs if the
emergency stop function is activated and restored
BATTERY
ON
CHARGE