9
16
TROUBLESHOOTING
Light does
not work
Fan does
not seem to
move much
air
Fan wobbles
or shakes
excessively
· Wires are not properly connected.
· Light bulbs are faulty.
· This fan is equipped with a 190 W
LIMITER that will automatically turn
the light off total wattage exceeds
the maximum wattage level.
· Fan is in reverse (blades are moving in
clockwise direction).
· Fan is not properly located.
· Screws securing fan blade clips to motor
are loose.
· Fan blade and its blade clip are not
fastened securely.
· Canopy and mounting bracket are not
tightened securely.
· Blades are unbalanced.
Touching
ceiling
· Ensure wire connector in switch
housing is connected.
· Unscrew light bulbs and discard
properly.
· Turn the power OFF and replace
the bulbs with lower wattage bulbs
so that the total wattage is below
190 W.
· Counter-clockwise (forward) is
recommended in warm weather.
rotation to stop. Use the eraser end
of a pencil to change the forward/
reverse slide switch.
· Place fan in the centre of the room
so there is at least 12" (30 cm)
between the end of the blades and
walls or other obstructions.
. Make sure that screws which attach
fan blade clips to motor are fastened
and tightened.
. Tighten screws of fan blade to blade
clip securely.
. Ensure that canopy and mounting
bracket are tightened securely to
ceiling joist.
. Check by selecting a point on the
ceiling above the tip of one of the
blades. Measure this distance and
ensure all blades are even (see Fig.
16). If all blade levels are not equal,
adjust accordingly (see Balancing Kit
Manual).
ENVIRONMENTAL PROTECTION
Discarded electrical appliances are recyclable and should not be discarded in your regular
domestic waste! Please actively support us in conserving resources and protecting the
environment by returning this appliance to a collection centre (if available).
Battery reclamation (please keep to comply with the local law).
Problem
Possible reason
Solution
