SMAX MODBUS®
output encoder position value has been set to
increment when the sensor moves in the direction
shown by the arrow in Figure 1; if the bit is “=1”
instead the output encoder position value has been
set to increment when the sensor moves in reverse of
the standard direction, i.e. in the opposite direction to
the one shown by the arrow in Figure 1. For any
further information on setting and using the
counting direction function refer to the
bit 2 … 7
Not used.
Byte 1
Alarm
bit 8
If value is “=1” one or more alarms are active; to
know in detail which alarm has been triggered, see
the
bit 9 … 15
Not used.
MAN SMAX MB E 1.2
Programming parameters
73 of 84
