Lika Posicontrol LD220 Series, User Manual, Page: 70 / 100

LD220
Output polarity 4
Polarity for the switching condition of Preselection 4 . For complete
information please refer to the Output polarity 1 parameter in the “6.7
Preselection 1 menu” section on page 61.
Output lock 4
Latch for the switching condition of
Preselection 4
. For complete information
please refer to the
Output lock 1
parameter in the “6.7 Preselection 1 menu”
section on page 61.
Start up delay 4 (s)
Start up delay setting for the switching condition of Preselection 4 . It is the
delay before starting the monitoring function.
This adjustment only applies to the switching conditions
1 - |RESULT|<=|
PRES|
and
4 - RESULT<=PRES
(see the
Mode 4
parameter on page 69). The
automatic start up suppression is activated when the parameter is switched on
and the display value is 0. The monitoring function remains deactivated until
the preset value / switching point is exceeded for the first time.
0 OFF No start up delay setting
1 AUTO
Automatic start up delay setting, until the
preselection value / switching point is exceeded for
the first time.
NOTE
Start up delay 1 (s) and Start up delay 2 (s) (see on pages 64 and 66
respectively) have a time-dependent start up delay setting.
Event color 4
Event-depending change of colour of the display for the switching condition of
Preselection 4
.
Event color 2
,
Event color 3
and
Event color 4
have the
highest priority and are allowed to overwrite the change of colour set next to
the
Event color 1
parameter. For complete information please refer to the
Event color 1 parameter in the “6.7 Preselection 1 menu” section on page 61.
MAN LD220 E 1.4.odt 6 – Menus and parameters 70 of 100