LD220
When you press the
key the
Edit Unit
menu
appears.
A measuring unit can be created using the arrow
keys (by pressing and holding the arrow key down
the characters scroll fast).
Press the
key to save the
Edit Unit
menu.
Press the
key to close the
Edit Unit
menu.
Average filter
It sets an average filter to avoid displaying fluctuations in the speed display.
0
No average calculation
1
Average value is calculated within 2 cycles
2
Average value is calculated within 4 cycles
3
Average value is calculated within 8 cycles
4
Average value is calculated within 16 cycles
Sampling time (s)
It allows to set the sampling interval at which the speed evaluation is carried
out. The value is expressed in seconds (s).
0.1
Minimum sampling interval
0.5
Default value
9.9
Maximum sampling interval
NOTE
value of the speed measurement must always be set
higher than the read-in cycle of two consecutive SSI telegrams (see the
value of the position display on page 56).
MAN LD220 E 1.4.odt
6 – Menus and parameters
59 of 100