MC150
5.5 J1 jumper (encoder power supply)
Position
Function
Left
+10Vdc +30Vdc
*
Right
+5Vdc
*
: see chapter “5.2 CON2 connections”.
5.6 J2 jumper (input signal level)
Position
Function
Left
Input connected with GND (CON3/Pin9)
Right
Input connected with +24Vdc
(CON3/Pin10)
6 - Functions
6.1 Start up
At start up the unit shows the software version
followed by actual position.
Software version:
SOF xx
6.2 Key functions
Key
Function
F
Function (save + exit setup)
Shift Right (select parameter / digit)
Up (change value)
E
Enter (save + scroll menu)
6.2.1 Default parameter
(factory settings)
Default parameter values are written in
BOLD
characters. The unit can be reset to default values
by pushing
F
,
and
E
key while switching on.
6.2.2 Direct functions
To set direct functions, such as reset, reset with
datum value, tool correction (offset value),
absolute/relative display mode and mm/Inch display
mode, program
P07
parameter.
7 - Set up
7.1 Access to setup menus
Push
F
key to enter setup.
•
push
to select
Func 1
or
Func 2
•
push
E
to scroll parameters
•
push
F
to exit setup
Admissible value range for each parameter is listed
as follows: [min. value, max. value]
7.2 Parameter setting
In order to activate modified parameters, switch off
and on the device.
Level 1: Func1
P00
Datum value / Eich [-99999, 999999]
Display can be set to datum value (or preset) by
activating SET input or pushing
key.
Default value:
50.0
Level 2: Func2
P00
Display value per distance moved [1, 10000]
Enter the value to be displayed when the unit
receives the number of pulses per distance moved
in parameter P01. Note this value is entered
without decimal.
Default value:
100
P01
Nr. of pulses per distance moved [1, 65000]
Enter the number of pulses per distance. This same
distance unit is used to determine the Display value
per distance moved.
Default value:
100
Example:
A ball screw moves 12.3mm per revolution. The
system uses a rotary encoder with 200 PPR (pulses
per revolution).
In this case:
P00 should be set to 123 (value without decimals)
P01 is 200
MAN MC150 I_E 1.7
11
www.lika.it
www.lika.biz
