IFS-10-PM programming & display unit
5.7 Edit parameters
Edit Data
menu can be found as follows:
After choosing the device to be edited in the first menu level press
the selectable parameters are shown. All the available parameters are listed in
the menu. For the IFS-10-PM display unit parameters see the “6 - IFS-10-PM
parameters list” section on page 27. For the IFS-10 safety unit parameters refer
to the “User's manual” of the safety unit.
to enter the menu for editing the
parameters. After confirmation by pressing the
OK
button, the parameter groups are shown on the
display.
Select the parameter to edit by using the arrow
buttons. The current value of the parameter
appears on the display too. After pressing the
OK
button, the parameter can be edited.
By using the left/right arrow buttons, the cursor
can be skipped to another position (the relevant
number flashes). By using the up/down arrow
buttons, the value can be changed. Press the
OK
button to confirm or the
C
button to exit the menu
and abort the entry.
WARNING
Parameters must be saved after any change.
This is important in order to ensure that the changes are effective also after the
power supply is switched off or when the IFS-10-PM display unit is removed
from the safety unit (see the “5.8 Save parameters” section on page 24).
WARNING
Changes in the parameters of the safety unit are only effective after saving
them (refer to the “5.8.1 Saving the parameters to the Safety Unit” section on
page 24).
MAN IFS-10-PM EN 1.1.odt
5 - Parametrization of the safety unit
23/44
