Lika AM 3616/4096BG Series, User Manual

Page: 32 / 36

AMx36 • SSI & BiSS C-mode
Save parameters on
EEPROM
function in
the
Command
register
48 01
or
Save parameters and
activate Preset
function in the
Command
register
48 02
WARNING
After having set the new counting direction or changed either the number of
information per revolution or the number of revolutions it is necessary to set
also a new preset.
f you set a new singleturn or multiturn resolution and a new preset value at the
same time and then use the
Save parameters and activate Preset
function in
order to activate the preset, please consider that the system stores the new
resolution values, but zero sets the preset value. Thus you need to enter it again.
Device type
[55, ro]
This register describes the type of device.
Default = 02h: multiturn rotary encoder with BiSS C-mode interface
(AMx36xx/4096SCx...)
N° of bits used for singleturn resolution
[56, ro]
This register shows the number of bits used for the current singleturn resolution
as set next to the
Information per revolution parameter (registers 4B … 4D).
Default = 14h (= 20 bits)
N° of bits used for multiturn resolution
[57, ro]
This register shows the number of bits used for the current multiturn resolution
as set next to the
Number of revolutions
parameter (registers 4E-4F).
Default = 10h (= 16 bits)
MAN AMx36 SSI_BiSS E 1.1.odt 6 - BiSS C-mode interface 32 of 36