User Guide
LigoDLB Configuration
LigoWave
Page 16
Enable management VLAN
– enable a VLAN tagging for management traffic. Access to the AP for
management purposes can further be limited using VLAN tagging. By defining Management VLAN,
the device will only accept management frames that have the appropriate Management VLAN ID. All
other frames using any management protocol will be rejected.
Management VLAN ID
– specify the VLAN ID [2-4095]. When device interfaces are configured with a
specific VLAN ID value, only management frames that matching configured VLAN ID will be accepted
by device.
When you specify a new management VLAN, your HTTP connection to the device will be
lost. For this reason, you should have a connection between your management station and
a port in the new management VLAN or connect to the new management VLAN through a
multi-VLAN router.
IPv4 Configuration
When assigning IP address make sure that the chosen IP address is unused and belongs
to the same IP subnet as your wired LAN, otherwise you will lose the connection to the
device from your current PC. If you enable the DHCP client, the browser will lose the
connection after saving, because the IP address assigned by the DHCP server is not
predictable.
IP method
– specify IP reception method: IP addresses can either be retrieved from a DHCP server
or configured manually:
§
Static
– the IP address must be specified manually.
§
Dynamic
– the IP address for this device will be assigned from the DHCP server. If DHCP server
is not available, the device will try to get an IP. If has no success, it will use pre-configured
fallback IP address. The fallback IP settings can be changed to custom values.
IP address
– specify IP address for device
Subnet mask
– specify a subnet mask for device.
Default gateway
– specify a gateway IP address for device.
DNS server
– specify the Domain Naming Server.
Secondary IP
– specify the alternative IP address and the netmask for unit management.
IPv6 Configuration
Click the
IPv6
slide to enable IPv6 configuration:
