8. Lightware Device Controller
UBEX series – Matrix Application Mode – User's Manual
84
8. Lightware Device Controller
UBEX series – Matrix Application Mode – User's Manual
84
MA
TRIX APPLIC
A
TION MODE
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
Settings Tab
Clicking on the Settings menu opens the settings panel of the endpoint.
Settings tab of the Device properties window - Receiver - Network tab
Status Tab
All important information are available about the receiver, e.g. the MAC address of device, firmware versions,
system uptime, voltages, and temperatures.
#status #firmwareversion
Network Tab
ATTENTION!
The network settings will be applied when the device is set to Extender mode. There is no
public IP address of the endpoint device when it is in Matrix mode.
IP address and DHCP settings can be set on this tab. Always press the Apply settings button to save changes.
Factory defaults settings can be recalled with a dedicated button. See the factory default settings of the
endpoint device in the
#network #dhcp #ipaddress #mac
8.11.3. Transceiver Mode
HDMI Out 1 Panel
Clicking on the HDMI out 1 panel opens the properties of the output port. The most important signal
information and settings are available from the panel.
Endpoint tab of the Device properties window - Transceiver - Output port properties
Settings
▪
HDCP mode
(Auto / Always);
#hdcp
▪
Power 5V mode
(Auto / Always on / Always off);
#power5v
▪
Timing mode
(Free run / Source locked);
#timingmode #freerun #sourcelocked
▪
Identify Stream / Identify Display
#identifystream #identifydisplay