2. Product Overview
MMX4x2 series – User's Manual
18
Applied firmware package: v1.6.0b19 | LDC software: v2.5.13b5
2.4.
Front Panel LEDs
Status LEDs
LIVE LED
off
The device is not powered.
green
blinking slow Device is powered and operational.
green
blinking fast
Device is in bootload mode (firmware update).
green
on
The device is powered but no operation.
AUDIO OUT LED
off
Embedded audio is not present or analog audio output is muted.
green
blinking
Embedded audio format is not supported for audio de-embedding.
green
on
Embedded audio is present and de-embedded.
OUT 1 AUTO LED
off
Autoselect is disabled on HDMI Output 1.
green
on
Autoselect is enabled on HDMI Output 1.
OUT 2 AUTO LED
off
Autoselect is disabled on HDMI Output 2.
green
on
Autoselect is enabled on HDMI Output 2.
INFO:
You can find more information about Autoselect feature in
Crosspoint Status LEDs
IN1..IN4 LEDs
green
blinking
Input is selected, signal is not present.
amber
blinking
Pre-programmed audio configuration (1..4) is selected by the Set Audio
Config button. See the details in the
green
on
Input is selected, signal is present.
2.5.
Rear Panel LEDs
HDMI input LEDs
off
Signal is not present on input.
green
on
Signal is present on input.
TPS input LED (only at MMX4x2-HT200 model)
off
No TPS link is established between the matrix and the transmitter.
green
blinking
Low power mode or Ethernet fallback mode is active, see details in the
Consumer Electronics Control (CEC) Interface
section.
green
on
TPS link is established.
HDMI output LEDs
off
Output signal is not present or muted.
green
on
Signal is present.
HDCP LEDs
off
Output signal is not HDCP-encrypted.
green
blinking
Non-HDCP capable device is connected, encrypted signal is replaced with
red screen.
green
on
Output signal is HDCP-encrypted.
