background image

 
 
SPECIFICATIONS 

Battery  

1 x RC2032 

Frequency 434.075MHz 
Range 

300 meters line-of-sight 

Safety Rating 

Extra Low Voltage 

Physical  

33 x 60 x 10mm  

Ambient Temp. 

0°C to +40°C

 

 

 
 
INTRODUCTION 

The Light Symphony keyfob remote control provides simple 
remote control over your garden lighting.  
 
This manual provides a basic guide to its functions and assumes 
your lighting is now installed and fully working. For more 
detailed information on the setting up of the system please refer to 
the instructions provided with Light Symphony’s other products. 
 
Before using the keyfob please fit a CR2032 battery. The battery 
is inserted by removing the 3 screws on the back of the unit and 
sliding it into the holder ‘+’ side up.  
 
Please read the section about “System Codes” to reduce the risk 
of interference with neighbouring systems. 

ISSUE 1.3 

COPYRIGHT © PM INTERNATIONAL LTD 2012 

KeyFob 

Environmental Information for Customers in the European Union 

 

 

European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its  

 

 

packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product  

 

 

should be disposed of separately from regular household  waste streams. It is your responsibility to dispose 

 

 

of this and other electric and electronic equipment via designated collection facilities appointed by the  

 

 

government or local authorities. Correct disposal and recycling will help prevent potential negative 

consequences to the environment and human health. For more detailed information about the disposal of your old 
equipment, please contact your local authorities, waste disposal service, or the shop where you purchased the product. 

Changing The Key Fuctions 
 
The keyfob is manufactured in two pre-set versions, as shown below.  
 
 
 
 
 
 
 
 
 
 
 
 
 

4-Zone

 

Master On/Off + 2 Zone

 

 Model 

LS30034FOB 

Model 

LS30032FOB 

 
 
However, it is possible to convert between these versions by replacing the keys with 
the spare button-caps provided. After replacing the button-caps, the new mode must be 
programmed by pressing and holding either the two left-hand or right-hand keys 
together until the LED lights, as shown below; 
 

OFF 

ON 

(

Press and 
hold to set  
2-zone mode 

OFF 

ON 

Press and 

hold to set 

4-zone mode

)

Reviews: