LightSpeed Technologies Cat 855, User Manual

Page: 9 / 45

9
1. Overview
2. Setup & Use
3. Optional
Accessories
4. T
roubleshooting
5. W
arranty
, Safety
& Specifications
1. SPEAKER OUTPUTS (1-2):
This
euro-block connector is used
to connect the CAT 855 to the
loudspeaker(s). Up to two 8-ohm
speakers can be connected to
each output.
2. CHARGERS:
These jacks can
be used to charge the optional
LightMic or handheld microphone
when purchased without REDMIKE
and cradle charger.
3. DC POWER:
Plug the power
supply (24V/2.5A) into this jack.
4. PAGING INPUT AND ADJ:
Connect the input from optional
PageFirst sensor here when
interface with a buildings paging
system. Use the ADJ control to
adjust the sensitivity if needed.
5. EQUALIZER (4-BAND): Adjust
these controls upon installation to
properly equalize the system to
produce optimum audio quality
from the microphone(s).
6. AUX OUT AND VOL:
This jack
sends audio to external equipment
such as an assistive listening
device (Personal FM System) or
recording device. Use the volume
control to set the optimum signal
level for the device.
7. AUDIO INPUTS:
These
connections accept an audio
signal from other technology so
all multimedia can be distributed
evenly throughout the classroom.
8. SENSOR INPUT:
The infrared
microphone audio from the ISR is
connected to this input via Cat 5
cable.
9. SENSOR SHORT: This LED glows
red when there is a short in the
ISR or cable. The system will not
operate, but is protected from
damage when the LED is lighted.
REAR PANEL CONTROLS
1
2
3
6
7
8
9
5
4