S331
Thank you for choosing a
lightSKIN product. LightSKIN
S331 seat post is a tail light
integrated product. Five
glare-free lights makes the rider
visible from all sides. Your safety
and visibility on the road is of
utmost importance to us.
The integrated lithium ion battery
is charged via the micro 2 USB
charging port beneath the saddle
clamp. The charge indicator
provides you with a charge
status. If the charging socket
lights up blue, the battery must
be charged and 1 hour of light
remains.
Note the two lower LEDs may be
sunk into the frame.
The maximum lighting duration is
15 hours for 3 LED operation and
10 hours for 5 LED operation. The
second LED from the top serves
as a switch, powering the unit on
and off and allowing mode switch
between three and five LED
operation.
Installation :
· Use the correct diameter corre-
sponding to your bicycle frame.
· Use the appropriate tool to
fasten the saddle support.
· Adhere to the safety lines of the
minimum and maximum insertion
heights.
· Be careful not to damage the
LEDs when inserting the seatpost
into the frame.
· The taillight may only be
operated in the following angular
range: Max76˚ , Min 70˚.
· The lower two LEDs may be
sunk in the frame. Always pay
attention to the maximum
insertion mark!
· The taillight must be mounted in
such a way that it is illuminated at
the rear. The reference axis (see
drawing) must be aligned parallel
to the bicycle's longitudinal axis.
Safety instructions :
· At startup, the product must be
dry. Remove any moisture before
riding.
· After installation, test that the
seatpost does not drop under
load.
· Take care that the LEDs are not
covered by a bag or clothing
when riding.
· Do not make any independent
changes to the product. Do not
try to open the product.
· The product contains lithium
batteries, which are subject to
special conditions in air traffic.
Please inquire with your airline or
forwarding agent before
transport.
USB port :
· Do not pull on the charging
cable excessively.
· Close the cover on the USB port
properly.
· If the USB connector is exposed
to heat, it may lose its shape.
· We recommend using the
supplied USB cable to ensure
proper battery charging. If you
use another cable, please make
sure that it is an original Micro
USB cable, in the dimensions
10mm wide and 7mm high.
· If the USB plug has deformed, it
must be replaced.
Malfunctions :
The LEDs are numbered from top
to bottom :
Warranty :
· Seatpost and light module : 2
years from the date of purchase.
· In case of warranty, (replacment
or repair), please contact the
distributor through whom the
product was purchased.
Waste Disposal :
· Packaging : The product
packaging is made of recyclable
materials. Dispose of these
environmentally friendly in the
provided collection containers.
· Product : Old appliances and
batteries must not be disposed of
with normal household waste.
According to EU Directive
2012/19/EU, the product must be
disposed of properly at the end
of its service life. Return the old
device to a collection point for
electronic waste or a recycling
center.
· If LED numbers 4 or 5, 4 and 5
are defective, it is okay to switch
to the 3-LED mode to save
battery.
Charging :
· In order to reach the full load
capacity, it takes between 2.5
and 3 hours.
· During charging, the first light
flashes with low light, the flashing
stops when the battery is
completely charged. When the
battery is fully charged, remove
the cable from the USB port.
· Should the product become
excessively hot during charging,
cancel the charging process.
· Never charge the battery when
the USB port is wet.
· Full charge and discharge
cycles : 500
Assembly :
· When fitting the saddle, please
make sure that the small
transparent rubber cap for the
micro USB connection is
clamped under the strut.
Operation :
· Control Modes : The second top
LED is used as an on/off/mode
control and to change between
the 3 and 5 light modes. The
maximum illumination time is 15
hours (3 LEDs), minimum illumi-
nation time is 10 hours (5 LEDs).
Off
> 5 LEDs > 3 LEDs
· Battery life : 5LEDs > 10 hours,
3LEDs > 15hours
· Low battery alert : When the
battery reaches a low charge
state (approximately 1 hour
remaining), the USB port lights
up blue. The battery must then be
charged.
No.1
No.2
No.3
No.4
No.5