IS: 6113V
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
B0201
Page 2 of 2
A
COMPANY
631 Airport Road, Fall River, MA 02720
B. WIRE-IN
For non-dimming ballast: Bare copper and / or green Insulated wire(s)
must be connected to supply ground. Connect white ballast lead(s) to
neutral (white) supply lead. Connect black ballast lead(s) to hot supply
lead. Use wire nuts (local hardware item)
For dimming ballast, see wiring diagram marked on ballast label and follow
dimmer instruction sheet.
C. CLOSE-IN
Close in ceiling, as required.
D. INSTALL REFLECTOR TRIM
See separate reflector trim instruction sheet.
* Lamp 2 is for 2 lt. fixtures
B. WIRE-IN
For non-dimming ballast: bare copper and / or green insulated wire(s)
must be connected to supply ground. Connect white ballast lead(s) to
neutral (white) supply lead. Connect black ballast lead(s) to hot supply
lead. Use wire nuts (local hardware item).
For dimming ballast, see wiring diagram marked on ballast label and
follow dimmer instruction sheet.
C. CLOSE-IN
(Fig.2)
Close in ceiling as required.
D. SNAP-IN
(Fig.3)
See separate reflector trim instruction sheet.
E. PUSH-IN
(Fig.4)
