READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
I S : 6 4 2 2 M C
0498
Page 1 of 2
INSTRUCTIONS FOR ATTACHING LYTESPOT
®
TO LYTESPAN
®
TRACK
For use with Lytespan
®
Track Systems Only
LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA 02720
1. Insert into LYTESPAN TRACK. (Fig. 1) LOCKING LEVER
must be on the same side of track as BEAD.
2. Rotate FITTING clockwise until LOCKING LEVER snaps
and locks in place. (Fig. 2 & 3)
3. To remove: depress LOCKING LEVER, then rotate FITTING
90° counterclockwise.
INSTRUCTIONS FOR ATTACHING LYTESPOT
®
TO
SINGLE CIRCUIT TRACK SYSTEMS
Fig. 1
BEAD
See Fig. 4. BRASS CONTACT can be raised or lowered.
Broken line indicates position for 1 circuit or lower circuit
of 2 circuit track system.
To convert attachment FITTING for upper circuit of 2 circuit
track, raise BRASS CONTACT to high position by lifting
CONTACT as high as stop permits and CONTACT clicks
into place.
INSTRUCTIONS FOR CONVERTING LYTESPOT
®
ATTACHMENT FITTINGS TO OPERATE ON 2
CIRCUIT TRACK
Fig. 2
Fig. 3
Fig. 4
LOCKING
LEVER
LYTESPAN TRACK
FITTING
LOCKING
LEVER
BRASS CONTACT
