8307U
ED17 Open/Square Lytespot
for Unprotected Lamp
8317U
ED17 Enclosed/Round Lytespot
for Unprotected Lamp
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:83ED17
C0104
Page 1 of 2
INSTRUCTIONS FOR ATTACHING 83ED17R SERIES REFLECTORS TO
POWERARC MODULAR ED17 LYTESPOT (ROUND OR SQUARE FRONT)
TM
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720
INSTRUCTIONS FOR ATTACHING 83ED17R SERIES
REFLECTORS TO A PowerArc ED17 SPOT:
(See chart below for compatible luminaires)
NOTE: Reflectors must be installed prior to lamps. After
reflector is installed, see IS:83S for installation, lamp-
ing, and operating instructions.
1. Orienting LABEL in the UP position, hold REFLECTOR
by the LIP and push into REFLECTOR CUP until
REFLECTOR SPRINGS engage. (See FIG. 6 and 7).
2. Rotate REFLECTOR clockwise until the REFLECTOR
SPRINGS hit the ROTATION STOPS on the REFLEC-
TOR CUP. (See FIG. 7)
To remove REFLECTOR:Remove lamp, rotate
REFLECTOR counterclockwise until REFLECTOR
SPRINGS snap into REMOVAL SLOTS. Pull REFLEC-
TOR out of REFLECTOR CUP. (See Fig. 7)
COMPATIBLE LUMINAIRES
Cat. No. Product Group
Description
8307
Lytespan Track
ED17 Open/Square Lytespot
for Protected Lamp
8317
ED17 Enclosed/Round Lytespot
for Protected Lamp
REMOVAL
SLOT
ROTATION
STOP
REFLECTOR
SPRING
REFLECTOR
LIP
REFLECTOR
SPRINGS
REFLECTOR
REFLECTOR
CUP
ED17
SPOT
REFLECTOR
LABEL
FIG. 6
FIG. 7
(UP POSITION)
