IS:C6E17OW
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTALLATION INSTRUCTIONS FOR 6" AND 7" RECESSED
EVOLUTION H.I.D. OPEN WALL WASHER DOWNLIGHT TRIMS.
INSTRUCTION SHEET NO.
A0904
Page 1 of 1
A
COMPANY
631 Airport Road, Fall River, MA 02720
CAUTION: (RISK OF FIRE) DO NOT INSTALL INSULATION ABOVE NOR WITHIN 3 INCHES (76mm) OF ANY
PART OF THE LUMINAIRE (LIGHTING FIXTURE)
CAUTION: USE ONLY ROUGH-IN SECTIONS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURERS’ ROUGH-IN KITS
WILL VOID THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.
LAMPHOLDER
(supplied with frame)
LAMPHOLDER
SPRING
(supplied with frame)
REFLECTOR NECK
Fig. 1
Installing Lampholder onto Reflector (Fig. 1)
1.
Bring LAMPHOLDER through frame opening into workspace.
2.
Snap LAMPHOLDER SPRING into two slots on REFLECTOR NECK.
3.
Check to make sure that both sides of LAMPHOLDER SPRING are fully engaged into
slots.
4.
Reflector trim is now ready for installation into ceiling.
Installing Reflector into Frame (Fig. 2) & (Fig. 3)
1.
Feed assembled REFLECTOR into frame opening by aligning WINDOW CUT OUT
between RETAINER SPRINGS. WINDOW CUT OUT must be opposite the wall to be
illuminated as shown.
2.
Push up on flange until it is fully installed into frame opening.
Re-lamping
1.
To re-lamp one-piece units, simply unscrew the old lamp and replace with a new one.
There is no need to remove trim from ceiling.
2.
See trim labeling for correct lamp info. Follow lamp manufacturer's directions for proper
care and handling of lamp.
Fig. 2
**Care and Maintenance of “Alzak” REFLECTOR TRIM finish
:**
If handling of REFLECTOR TRIM with anodized or Alzak finish is required, the use of clean white or plastic film gloves is recommended to avoid fingerprints.
Anodized or Alzak surfaces can be cleaned by the following methods:
1.
Wipe off with a soft, clean, dry, lint-free cloth.
2.
Wipe off with a soft clean cloth dampened in mild detergent solution.
Rinse, then wipe dry with lint-free cloth or paper towel.
3.
Wipe off with a clean cloth dampened with a solution of wetting agent and water (such as 2 oz. Per gallon “Pluronic L62-LF” by Wyandotte Products). Wipe dry.
4.
Use a liquid wax such as Glass Wax
®
. Avoid gritty cleaning agents.
RETAINER
SPRINGS
WINDOW
CUT OUT
Fig. 3
WALL TO BE
ILLUMINATED
WINDOW
CUT OUT
