4
LIGHTMEN™
1.1 MAINTENANCE
Maintenance and cleaning the unit
»
Make sure the area below the installation place is free from unwanted persons during setup.
»
Swich of the unit, unplug the main cable and wait until the unit has cooled down.
»
All screws used for installing the device and any of its parts should be tightly fastened and should not be
corroded.
»
Housings, fixations and installation spots (ceiling, trusses, suspensions) should be totaly free from any
deformation.
»
The main cables must be in impeccable condition and should be replaced immediately even when a small
problem is detected.
»
It is recommended to clean the front at regular intervals, from impurities caused by dust, smoke, or other
particles to ensure that the light is radiated at maximum brightness. For cleaning, disconnect the main plug
from the socket. Use a soft, clean cloth moistened with a mild detergent. Then carefully wipe the part dry. For
cleaning other housing parts use only a soft, clean cloth. Never use a liquid, it might penetrate the unit and
cause damage to it.
Troubleshooting
Contact an authorized service center in case of technical problems or not reported in the table can not be resolved by
the procedure given in the table.