ENGLISH
Safety instructions:
DANGER! (For babies and children)
Packaging, plastic films and other packaging materials must be properly stored or
disposed of. They must be kept out of the reach of babies and children due to the
risk of
suffocation
.
Make sure that children never use the device unattended! In addition, make sure that
children do not remove any (small) parts from the device, as they could suffocate by
swallowing them!
DANGER! (Electrical shock due to high voltages in the device)
Do not remove the housing. There are no parts to be maintained in the device. Inside the
device there are components which are under high electrical voltage.
The device must not be used as soon as damage or the absence of components,
protective devices or housing parts is noticed!
DANGER! (Electric shock caused by short circuit)
Modifications to the power cord or plug are prohibited. Failure to do so may result in fire
or death due to electric shock!
NOTE! (Fire hazard)
Ensure that the unit is not exposed to a direct source of heat and is used away from open
fire. Never cover or tape any ventilation slits or the device itself.
NOTE! (Operating conditions)
Due to its structural characteristics, the device is designed for indoor use. Never expose
the device to rain, moisture or liquids as this may cause damage. Vibrations, dirt or
sunlight can also cause damage - avoid them!
NOTE! (Power supply)
It is essential that you check that the device voltage matches your local mains voltage. It
is strongly recommended that you fuse your mains socket with a residual current circuit
breaker (FI).
If you do not use your device for a longer period of time, disconnect it from the mains.
to minimize danger. The same applies to storm conditions such as thunderstorms or
floods, etc..
Installation:
Be sure to check the unit for damage before using it. Optimally, use the original packaging or
suitable transport or storage packaging to protect the product from dust, moisture, etc. when not
in use.
The unit can be installed upright or suspended. The device must always be attached to a solid,
approved carrier or a suitable surface. The opening in the product bracket must be used to fasten
the device. Always provide a second, independent safety device for the device, e.g. a safety
device.
