ENGLISH
Maintenance:
-
IMPORTANT
: Always set the output to Zero and wait for minimum 30 seconds before to
switch off the unit.This allows the unit to execute its cleaning process so all the remaining
fluid is removed from the internal circuits.
-
Switch off the unit, unplug the mains cable and wait 10 minutes until the unit has been
cooled down.
During inspection the following points should be checked:
-
All screws used for installing the device and any of its parts should be tightly fastened and
may not be corroded.
-
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free
from any deformation.
-
The mains cables must be in impeccable condition and should be replaced immediately when
even a small problem is detected.
Instructions for refilling of the water tank:
Water level[MAX] LED
: indicates there is still enough water in the water tank to run the
machine.
Water level[MIN] LED
: indicates the water level in the tank is too low. A warning is given in 2
steps:
- LED Blinking
:(LCD-display shows: Water Level low! Please add water)
The water level is too low: water needs to be added in the water tank.
- LED ON
: (LCD display shows: Water tank empty! Machine stopped)
The water level is dangerously low so the machine stopped working: waters need to be added in
the water tank.
Instructions for refilling of the fluid tank:
Fog fluid should be added when the machine shows"
FOG FLUID EMPTY
".
