Preliminary Manual
18
With next you will access the
Repeats Menu
Here you can adjust following parameters:
PreBlank On Repeats
It’s the time delay in repeats before the scanner reaches a blanked point and blanks because of his
mass inertia.
PreBlank Off Repeats
It’s the time delay before the blanking will be turned off.
PostBlank On Repeats
These are the numbers of repeats before the Picture will be shown.
PostBlank Off Repeats
These are the repeats which needed to delay the projection in order to put on the beam on again.
To start point repeats
After the output of the last picture point of a Gobo the scanner moves again to the start point of the
Gobo as fast as possible. Because of the mass inertia of the scanning mirror that takes some time.
To be sure that the scanner is again at the start point some start point repeats can be added.
Swap XY
Here you can swap the X with Y axis of the output. The picture will be turned 90 degrees.
Repeats:
Exit
Back
Next
Channel: 1/2
<
>
Blank On:
Blank Off:
Picture:
Pre:
Post:
00
00
06
06
06
19
Summary of Contents for Laserlink
Page 41: ...Preliminary Manual 41 ...