1.3. Fix the housing on bearing surface with screws not more 5 mm in diameter (not included)
using 4 sealing rings between luminaire and surface for each mounting point (on fig. a - bearing
surface, b - sealing ring, c – ring, d - fixing screw, f – luminaire).
2. Mounting in “Armstrong” type ceiling.
2.1. Remove frame by clicking springs out of their slots, cut off the cable’s gland tip and put the
mains cable through it into luminaire's body.
2.2. Place the luminaire into "Armstrong" type ceiling cell.
3. Connect mains wires to terminal block according to polarity shown.
4. Replace the frame back.
5. When dimmable control gear is used, control wires polarity must follow label markings.
6. Installation of GRILIATO ceiling light.
Install suspensions at ceiling hooks installed beforehand.
6.1. Install the light in 600x600 mm ceiling cell and install suspensions to holes in side walls of
the light.
6.2. Align planes of the light and the ceiling by releasing the spring to adjust the suspension
length. Assemble the ceiling.
23
