2. Click the leg into luminaire’s casing.
3. Put the mains cable through the hole in the casing. Attach the casing to bearing surface.
4. Place the casing on surface.
5. Connect mains cable to terminals according to polarity shown.
6. When regulated control gear is used, control wires polarity must follow label markings.
7. Insert lamp. Replace the diffuser by clicking it into luminaire’s casing with springs or mounting
clips.
8. Luminaire installation should be done with X4 mounting hardware kit (doesn’t included). Using
of other mounting hardware will void the warranty.
9. Check test by the means of TELEMANDO device. It is possible to carry out the check test by
connecting the TELEMANDO (TM) device: if the power is present pressing the ON button (on
TELEMANDO device) will activate the luminaire’s emergency state which will continue until the
ON button is released. Telemando device can service up to 35 luminaries (see connection
diagram). The OFF button is not used.
20