“Riviera” LightHeaded™ Bed
Assembly Instructions
www.LightHeadedBeds.com
Model #20204Twin size, Cheshire Cherry
Model #20321Twin size, Black
Model #20324 Twin size, White
9/17/2015
1168344 B
Step 3
Step 4
1. Open the caprail, and remove the protective foam insert and attached paper and
discard.
2. Your LightHeaded™ light component is pre-assembled in the headboard and ready to
use. Please refer to your LightHeaded™ Lighting Assembly Instructions in the TechBox
for information on how to connect power to your light, insert LightHeaded™ Images,
general use, and troubleshooting if necessary.
1. With the help of your assistant, gently lay your LightHeaded™
headboard panel face down on a soft surface with the hinged top in
the open position.
2. Align left leg (EPP) with the left side headboard (EPN).
3. Align the cutout in the top of the leg with the corresponding cutout
in the bottom of the headboard post. The 4 holes in the leg should
align with the 4 threaded inserts in the back of your headboard
panel.
4. Select 4 metal washers (EPJ), 4 metal lock washers (EPK), and 4
machine screws (EPL). Using the Allen wrench supplied (CWT),
tighten screws into legs through the lock washer then washer.
5. Repeat these steps for the right leg (EPO).
Mattress only
Box Spring & Mattress
or
Step 3-1
Step 3-2
1.
If you’re using a box spring and mattress, hook your
wooden side rails (EPR, EPS) onto the bottom two
metal pins in the vertical slot on the headboard and
footboard legs.
2.
If you’re using a mattress only, hook your wooden side
rails (EPR, EPS) onto the top two metal pins in the
vertical slot on the headboard and footboard legs.
Page 3
Step 5
It’s your choice!
Your LightHeaded™ bed can be assembled to use a box
spring and mattress set or a mattress only. Don’t worry,
you can change it at any time with a couple simple
steps and no tools.
EPN
EPO
EPP
