3
3
GENERAL CARE AND SAFETY TIPS
To wash your lights, use plenty of warm soapy water and a soft cloth only (this prevents surfaces
from marking). Never use any solvent based cleaners or industrial detergents when cleaning these lights.
Handle the base of the bulb only, if the glass gets dirty then clean with isopropyl alcohol or methylated
spirits.
WARNING
High intensity light source. Do not look directly into the light during operation, eye injury may result.
IMPORTANT NOTES
1. Mounting points vary in design and load capacity. Ensure the light is within the manufacturer’s
recommended weight specifications before fitment
2. Before fitting the stainless steel hardware, it is recommended that you apply a small amount of anti-seize
to the thread of the 35mm mounting bolts
3. The optional Xtreme Top Stay Bracket (HTXMK2TSB) provides additional stability during extreme driving
conditions (included with 24V version only).
MOUNTING BRACKET
1. Remove Nyloc
®
nut and M10 washer from M10 x 35mm bolt attached to the bottom of mounting bracket
2. Locate the bracket in a suitable position using the M10 x 35mm bolt. It is recommended that the base
area of the mounting bracket is totally supported
3. Align the light to the preferred driving position
4. Fit the washer and M10 Nyloc
®
nut then tighten using a 17mm socket and ratchet to specified torque
(35Nm) - do not use a rattle gun
5. Tighten 2 x M10 x 35mm side bolts to the recommended torque (35Nm).
