Actual product characteristics may vary. Light Culture Australia Pty Ltd reserves the right to improve, modify or update the product designs without prior
notice.
www.lightculture.com.au
–
LED Neon must always be used in conjunction with a
certified Bright Light 24V DC power supply.
–
Check the polarity of the connector before inserting the
front connector and switching on the mains power.
–
To minimise voltage drop and ensure consistent light
output, position the power supply near to the power
feed end of the LED Neon, and keep the line as short as
possible.
–
Ensure to add 20% buffer when selecting a power supply.
–
Ensure your maximum run per power feed adheres to the
guidelines; 10m when using a single connector, or 20m
when using both connectors (see specification sheet).
–
Before making any cuts, installation, maintenance, or
connection, be sure the mains power is disconnected.
–
If essential; cut and connect LED Neon correctly. Any
incorrect operation can cause damage.
–
All connector joints must be connected correctly to
achieve connector IP rating.
NEON MICRO ARC | HORIZONTAL BENDING | ELECTRICAL AND PHYSICAL INSTALLATION GUIDE
WIRING DIAGRAM
POWER SUPPLY
DIMMER
optional
black wire: -
red wire: +
24V DC
–
Ensure the supply cord is not subject to mechanical stress
–
Keep 10–20mm distance between the end of the profile and the end mounting piece
–
The bend angle should be less than 15 degrees when installing LED Neon into the profile by hand
PROFILE INSTALLATION REQUIREMENTS