MOUNTING INSTRUCTIONS
A N G U S W I T H
P E R M A N E N T S E C O N D A R Y U N I T
Fig. 5
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 6
Included in the package:
• Angus with permanent
secondary unit
• Hardware kit
• Nik mount
• Nik mounting hardware
1. Install the Angus unit per the instructions on the reverse side. To
install Nik, follow the instructions below, respective to how Nik will
be mounted:
C L A M P M O U N T :
1. Slide unit mount onto edge of surface
(Fig. 4)
.
2. Tighten thumbscrews on the underside of the surface
(Fig. 5)
.
U N D E R S U R F A C E M O U N T :
1. Locate mounting bracket where desired and place a small mark in
each slot. Remove bracket.
2. Using the pilot drill bit, drill a hole on each mark that is ½” deep.
3. Attach mounting bracket to the underside of the surface utilizing
the two slotted holes
(Fig. 6)
. Do not filly tighten screws.
4. Align bracket to final desired position and drive the third screw thru
the remaining hole
(Fig. 7)
. Tighten all screws.
5. Feed unit thru the mounting bracket making sure to pass the
threaded stud thru the hole in the back of the bracket
(Fig. 8)
.
6. Fix the unit in place with the provided thumb nut
(Fig. 9)
.
Tools required:
• Pencil
• Philips Head screwdriver
• Drill
• 1/8” drill Bit
