1
THANK YOU FOR PURCHASING OUR PRODUCTS
.
Every unit has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the
outer and inner packaging for damage that may have occurred during shipping. If the carton appears to be
damaged, carefully inspect your fixture for any damage and be sure all accessories necessary to operate the
unit have arrived intact. In case damage has been found or parts are missing, please contact the distributor or
your dealer for further instructions. Do not return this unit to your dealer without first contacting them.
1.
SAFETY INFORMATION
Before operating this unit, please carefully read this manual and keep for
usage in the future. It is necessary to respect the following rules.
Disposal of the device after its life cycle can damage the environment. Take
it to a recycling company or return it to the authorized dealer.
The products referred to in this manual conform to the guidelines of the
European Community and are therefore marked with the CE logo.
Keep this device away from children and unauthorized users. The dealer is
not liable for damage as a result of ignoring the information in this manual
and incorrect operation.
Before operating this unit, please make sure the housing is in good condition
and ensure pan and tilt can rotate in full range.
0.5M
Ensure that a minimum distance of 0.5 m is maintained between the fixture
and any flammable material.
The device can only function with 100-240v voltage, 50 / 60Hz power. Do not
connect to any other power supply. Disconnect the device from the power
supply before opening it or before maintenance.
Never look directly into the projecting lens when the fixture is switched on.
The light can cause epileptic seizures in light-sensitive people or people with
epilepsy. Extreme caution and compliance with these safety instructions are
required, especially with beam effects.
Do not place or install the device on a surface that is exposed to vibration or
any movement.
-
15⁰C + 45⁰C
The device should operate in temperature range -15 °C and + 45 °C. Do not
use the device if the temperature exceeds this range.
The lens shield must be replaced if it is broken. Never use the device if the
shield is not fully closed.
Safety I class device must be earthed.
When the fixture is mounted overhead, the safety rope must be attached to
the correct mounting location on the bottom of the device.
Please note that damage caused by manual changes to the device is not
covered by the warranty.
♲
If possible, recycle all packaging material
