Light for Life UC3.400, User Manual, Page: 8 / 48

8
UC3.400 User Guide
The existing cigarette plug connector contains an 8 amp “fast blow” fuse
that must be replaced with an equivalent value if it is ever removed from
the charger’s power cord.
All wire runs should be short as possible and use 14AWG wire.
All wire terminations should be crimped using only recommended tools
AND SOLDERED to minimize resistance.
• Do not splice into existing ground or power wires.
• Do not share crimp connectors with any other electrical device.
• Do not use multiple butt connectors on a single run of wire.
• The charger positive wire should exist on its own fuse.
• Do not share power with other devices.
Please contact the service team of 5.11 Tactical® at (866) 451-1726 in the
U.S. and Internationally at +46 40 467 388 or an authorized distributor for
authorized hardwire installation procedures and components.
E. AC Adapter Instructions
The 5.11 AC adapter converts the AC power in your home or office to a
direct current (DC) power source required by your Light For LifeTM charg-
ing unit. It replaces the 12 Volt DC power that is used when the charger is
connected to the DC outlet or cigarette lighter outlet in your vehicle.
Set Up Instructions
1. Remove the AC power cord from the box and insert the small end of
the dual line cord into the female receptacle on the adapter.
2. Insert the large end of the line cord into your AC power source or
wall outlet.
3. Connect the large female “cigarette plug” on the adapter to the
male plug attached to the flashlight charger.
ENGLISH
TAC59063_UC3400_UserGuide_510.indd 8 5/10/10 4:38 PM