Light Efficient Design
Tel: (847) 380-3540
www.led-llc.com
LAMP HOLDER
WIRES
WIRE
CONNECTORS
Installation Instructions Crouse-Hinds Champ® VMV
LED-8929***-HAZ & LED-8929***C-HAZ
5
Lamp Installation
9. Remove the optical assembly covering the
lamp such as guards, globes or external
reflectors by un-threading.
10. Remove old lamp
11. Firmly tighten LED lamp enough to depress the
center contact of the lamp holder.
12. Replace the optical assembly by threading into
the ballast housing.
13. Apply the silver adhesive label over the
current label on the luminaire which specifies
the replacement lamp and where it will be
visible during re-lamping.
14. Re-connect electrical power to the luminaire
at the supply source
Example Globe and Guard
5. Remove the wire connectors from the lamp
holder wires.
6. Using the included wire connectors connect
the lamp holder wires to incoming wires.
7. Cap off the unused wires with the wire
connectors removed earlier.
8. Place the ballast housing hinge pin over the
cover hinge. Close and secure the ballast
housing and cover by tightening the screw.
