Light Bright
Formled 9 AUV
3. Unpacking the device
Contents of the package: The spotlight, a Powercon True1 connection cable and an IR
remote control.
Open the packaging carefully on the top side and check the headlight and accessories for
possible transport damage. These should be reported immediately to the transport company.
4. Installation
The device comes with a ready made-up Powercon True1 connection cable. Please use only
the supplied cable or a cable of the same type assembled by a specialist. The connection of
the device to the power supply must also be carried out by an authorized specialist.
Connection in Germany/Europe:
Connected loads: voltage 100-240 V, frequency 50 - 60 Hz, power max. 110 VA
The electrical safety as well as the function of the device is only guaranteed if it is connected
to a properly installed protective conductor system. It is very important that this basic safety
requirement is present. In case of doubt, have the electrical installation checked by a
specialist. The manufacturer cannot be held responsible for damage caused by a missing or
interrupted protective conductor (e.g. electric shock)! Only use the device in a completely
assembled state so that no electrical components can be touched. (
danger 100-240 V
)
If you have observed the listed points, you can plug in the devices or have them connected to
the mains by a specialist.
ATTENTION: The spotlight may light up immediately if standalone
operation is activated or a DMX signal is applied!
Conductor color
Function
Symbol
Brown
Phase
„L“
Blue
Neutral conductor
„N"
Yellow/green
Protective earth
„PE“
⏚
6
