STEP 3
- SETTING THE CLOCK
NOTE: Any time that you need to reset the clock, press and hold SET CLOCK
until the flashing “12hr” appears, and repeat all parts of STEP 3.
1.
On the time display, “12hr” is flashing. To select 24 hour time, press
+ or – .
2. Press SET CLOCK. The hour will flash. To change the hour, press + or – .
3. Press SET CLOCK. The minute will flash. To change the minute, press + or – .
4. Press SET CLOCK. The year will flash. To change the year, press + or – .
5. Press SET CLOCK. The small “m” and “d” will flash. To change to a day-first
display of the date, press + or – .
6. Press SET CLOCK. The month will flash. To change the month, press + or – .
8 . Press SET CLOCK. The “E” (for English) will flash. To change
to Spanish or French, press + or – . Press SET CLOCK again.
9. The clock will show the day of the week to the right of the date.
If you prefer to display the year instead, press SET CLOCK again.
STEP 4
- SETTING THE WAKE-UP ALARM
NOTE: Any time that you need to reset the wake-up alarm time, press and hold
SET ALARM until the hour is flashing and repeat all parts of STEP 4.
1. Press and hold SET ALARM until the wake-up hour flashes. To set the hour , press + or – .
2. Press SET ALARM. The minute will flash. To set the minute, press + or – .
You can adjust the volume of your wake-up alarm to high or low with the HI - LO slider
switch on top. If there is a fire emergency the alarm will sound at maximum volume.
TROUBLESHOOTING ERROR MESSAGES
PLEASE READ THE USER’S MANUAL COMPLETELY AND THOROUGHLY FOR
FURTHER DIRECTIONS, PRODUCT FEATURES AND WARRANTY INFORMATION
800 Research Parkway, Suite 339
Oklahoma City, OK 73104
7. Press SET CLOCK. The day will flash. To change the day, press + or – .
3. Press ON/OFF to enable or disable the wake-up alarm. The bell icon at lower
Doc# LTQSG100 110831
For more information, go to www.lifetonesafety.com
or call Customer Service 1-800-648-7923
MODEL HLAC100
Battery ERROR
Bed shaker ERROR
Bed shaker unplugged
BEEP!
BEEP!
Batteries:
If the clock is flashing “BATT” and beeping at one minute intervals, the
batteries were not installed, were installed with the wrong polarity, or are below
the required voltage. Remove and insert them again or replace them if necessary.
Be sure to match the polarity (+ and –) signs in the battery compartment. To keep
your compatibility set-up, leave the clock plugged in while you change batteries.
Bedshaker:
If the screen is flashing “
beds
” and the clock beeps, the bed shaker has come
unplugged. Seat the bed shaker plug firmly into the jack on the back of the clock.
NOTE: If you decide you don’t want to use the bed shaker after it has been installed,
unplug the bed shaker then press and hold the red TEST/SILENCE button on the back of
the clock for 2 seconds. That starts a manual self-test that will display “TEST” for 10 to 20
seconds, sound the fire alarm once, and “retrain” the clock to operate without a bed shaker.
Buttons on the top of the Lifetone HL™
left will appear or disappear to indicate whether the alarm is active or inactive.
WAKE-UP TIME
BELL
NOTE: Any time that you want to restore use of the bed shaker, simply plug it in.
HOUR
MINUTE
DAY
MONTH
MONTH OR
DAY FIRST
YEAR,
LANGUAGE,
DAY OF WEEK
(OR DAY)
(OR MONTH)
KEEP THIS QUICK-START GUIDE IN A SAFE PLACE
