9
Required For This Page:
JA (1)
HD919
MP
BP
JA
This step cannot be reversed.
Line up the holes in the Middle Pole (MP)
with the slots in the Bottom Pole (BP) and
slide the Middle Pole over the Bottom Pole.
Make sure the square portion
of the Bolt is completely
inside the square hole.
Only finger tighten the Nut (JB).
Do not jam the poles together until instructed.
JB
The Cap Nut should be
on the side of the pole
with the Spring Bracket.
TP
BP
Strike each end of the pole firmly 5 to 6 times on a piece of
scrap wood or cardboard.
Do not hit your feet with the pole
sections, as serious injury could occur.
Tighten the Cap Nuts (JB) installed in steps 2
and 3. Make sure the Cap Nuts don’t break.
MP
WARNING
Failure to seat the pole sections together and secure
the Carriage Bolts could cause the pole sections to
separate, resulting in severe personal injuries as
listed on Page Two, or property damage.
If the end of the Bolt breaks through the plastic
cap, call our Customer Service Department at the
number on Page Two. Exposed threads on the
end of the Bolt may cause serious injuries.
WARNING
Jb
(1)
7/16” Wrench Scrap Wood
