34
TORQUE II
11. WARRANTY
AUSTRALIAN CONSUMER LAW
Many of our products come with a guarantee or warranty from the manufacturer. In addition, they come with
guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement
or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.
You are entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure. Full details of your consumer rights may be found at
www.consumerlaw.gov.au
Please visit our website to view our full warranty terms and conditions:
http://www.lifespanonline.com.au/Warranty-Policy
Please email us through
for all warranty or support issues.
TROUBLE SHOOTING
CODE
REASON
SOLUTION
E01
Message failure between computer
and bottom control board
A. Check the computer and bottom control board wire
connection;
B. Check if IC on bottom control board is loose, reset
the IC
C. Power on bottom control board, if there is an error,
change the bottom control board
E02
Burst clash
1
．
Check that the power voltage is suitable, if not, use
correct power voltage;
2
．
Check if the bottom control is burnt out; if yes -
replace; then reconnect the motor wire.
E05
Current overload protection
1. Over rated loaded or the motor is stuck, causing
excessive current, machine will start self-protection
system. Adjust the machine and restart;
2. Check if there is irregular noise coming from the
motor or if the motor / bottom control board is burnt
out; if burnt out, change to a good motor and
bottom control; remember to use the correct
voltage.
E08
EEPROM with problem
Change the bottom control board
